TA: Transformer Testing Lesson #5: No-load loss and current measurement – open for registration!
The lesson will be held on 27 August 2020 at 2 PM CET.
Image for illustration purposes
The fifth lesson in the Transformer Testing course – No-load loss and current measurement – hosted by Balazs Sztari at the Transformers Academy – is open for registration.
The lesson will be held on 27 August 2020 at 2 PM CET.
If you have attended (or registered for the) fourth live lesson in this course, please, just pay attention to your email inbox, to receive again the room link and password.
If you didn’t register earlier, please, go here to register and attend the fifth lesson.
About the lesson
No-load loss and no-load current measurements are elementary parts of every transformer factory acceptance test. These are very important and guaranteed parameters of the transformer, thus their correct and accurate measurement is essential.
In the fifth lesson of Transformer Testing Course, you will learn about the basics and techniques of these tests with the usual detailed explanations.
Learn about relevant standards, test and evaluation methods, and requirements for test equipment of no-load loss and current measurement of power transformers.
In case you wish to attend previously held sessions, they are now available in the pre-recorded form, and you can attend them here:
Transformer testing e-lesson #1
Transformer testing e-lesson #2
Transformer testing e-lesson #3